Looking at an old Hobie 14....right hull has a slow leak, and both hulls have had the bottoms glassed over a fair bit. Sail has a couple of Dacron sail tape repairs. Tramp looks to be in "ok" condition for now. Hulls look like it was a messy glass job with drip lines running up both hulls the whole way down. I was wondering if one could simply sand down the drip lines and repaint over the old paint with a fresh coat of boat polyurethane or something? What would be the best paint to use on this? Could I paint the entire hull, or would that make the "foot pads" on the top slippery? This doesn't have a trailer and just gets stored on the lake shore. I'm not looking for a racer, just something to toss around after work for a couple of hours. Originally I wanted a Hobie 16, but at $250 I'm willing to warm up on a 14 unless it is just a bad deal all around. I don't mind putting a few dollars and some time into it. I appreciate any advice and input.