Pulled the bridle plate off the port hull back at Easter, did a quick fix with a piece of metal screwed over the top and epoxied down. Later put same repair to stbd side to prevent plate ripping off. Both have held till now but look ugly and were only ever temporary.
Had always planned to do permanent repair job, thought I'd better get it done before Nats.
The underlying timber reinforcing appears to have little hold for the screws anymore, maybe a few holes and repairs have occurred before?
Do I cut a hole in the deck and replace the timber block underneath?
Then replace deck and glass over?
Am I going to weaken the deck / hull integrity due to 2 joints across the deck now?
Do I just reinforce the deck with glass and use a broader plate to spread load, much like I've done but make it look pretty?
Second option does not involve cutting through deck surface.
