I test my mast by first removing the mast rotator arm. I plug the hole on one side of the mast with tape, then have an assistant pressurize the mast through the remaining hole with a reversed shop vac. While air is being blown into the mast, I apply a solution of dish soap and water to all fittings and areas of possible leaks. Soapy bubbles will appear at any leaks. (I also use this method to test my hulls. Be careful with the hulls not to over-pressurize, though.)
<br>
<br>Cheers,<br><br> Kevin Rose
<br>N6.0na #215
<br>kevin@paddleways.com
<br>