Stephen,



I have had the spinnaker haylard come out with one cleat, but it was because of the angle going into the block was too high. Sounds like you have a straight shot and it still pulled - wow.



Based on the I-20 design where there is a block mounted to the front beam which then goes to a cleat on the front beam, I have added a block tied to a line then secured to the dolphin striker. I'm thinking that this will still allow the line to come down the mast then through the block and to the cleat on the font beam. If I can't get this to work, then I will just rivot on a swivel cleat above the downhaul blocks and run it from there. The only real problem I have with this is that there is an extra block swiging on the mast when I'm not using the spinnaker.



Steve

P19+spi 969